Find Out The Hottest Semiconductor Trends That Will Reward Your Business In The Long Run.
Total Reports: 245
The capacitor is a component that has the ability to store energy in the form of an electrical charge, producing a potential difference (Static Voltage) across its plates, similar to a small rechargeable battery. The basic structure of all capacitors is the same. A non-conductive material, called dielectric, separates two
Rep Id : TMRGL84894 | Published | Electronics and Semiconductors | August 2022
Oil condition monitoring (OCM) is an important element of any predictive maintenance program. OCM entails measuring, monitoring, and analyzing changes in lubricant and fuel oil for contamination and chemical content, as well as tracking oil quality degradation from new to end-of-life. Accurate, high-quality oil condition analysis, or oil quality monitoring,
Rep Id : TMRGL36209 | Published | Electronics and Semiconductors | August 2022
A pressure sensor transducer converts input mechanical pressure in gases or liquids to an electrical output signal. It consists of a pressure-sensitive element, which can measure, detect, or monitor the pressure being applied, and electronic components that convert the information to an electrical output signal. The physical deformation of strain
Rep Id : TMRGL82194 | Published | Electronics and Semiconductors | July 2022
An inductor is used to store electrical energy in the form of magnetic energy. It is a passive element with two terminals, and it also commonly known as coil or a reactor. The initial purpose of an inductor is to maintain stability in a circuit that has a varying voltage
Rep Id : TMRGL22787 | Published | Electronics and Semiconductors | July 2022
Inspection drones are automating the manual inspection process and enabling inspectors to enhance their inspection speed for collection of data, while eliminating the slower manual steps of labor and extra time that place them in hazardous situations. The rapidly-growing agriculture industry is fueling the market, as drones are proving to
Rep Id : TMRGL56634 | Published | Electronics and Semiconductors | July 2022
An ultraviolet (UV) analyzer uses ultraviolet light to determine the absorbency of a substance. In simple terms, the technique maps the interaction between light and matter. Matter undergoes either excitation or de-excitation, as it absorbs light, which generates what is known as a spectrum. This enables the measurement of the
Rep Id : TMRGL51153 | Published | Electronics and Semiconductors | July 2022
Battery management systems are available in either master-slave or single-board architecture; and are used for overcharge/deep discharge, over/under voltage, overcurrent, over/under temperature, pre-charge, and short circuit protection. They are integrated with specific algorithms such as SOC, SOH, cell/ module balancing, and real-time control overcharge/discharge current. Rise in demand for battery
Rep Id : TMRGL12116 | Published | Electronics and Semiconductors | July 2022
Robotic systems on construction sites drastically reduce construction time and enhance safety by replacing construction workers engaged in monotonous or dangerous operations. The inherent complexity of construction tasks, labor-intensive modeling, and uniqueness of design require significant human effort and expertise.
Rep Id : TMRGL56457 | Published | Electronics and Semiconductors | June 2022
Rise in concerns about emission of CO2 of old transmission and distribution networks has triggered the demand for the installation of new medium voltage switchgear assembly. Low and medium voltage switchgears are directly linked to reliability of the supply of electricity.
Rep Id : TMRGL3937 | Published | Electronics and Semiconductors | June 2022
Product prototyping is used to rapidly produce physical part of the product directly from its CAD model, using subtractive and additive manufacturing methods. It can be used for any product development cycle for components or sub-components. Product prototype and design testing is an integral part of new product development.
Rep Id : TMRGL84833 | Published | Electronics and Semiconductors | June 2022
Spintronic is an emerging field for next-generation nanoelectronic devices that aims to minimize the consumption of power while increasing memory and processing capacities. These devices use electrons' and/or holes' spin degrees of freedom, which can interact with their orbital moments. Spintronic devices are used in the field of mass-storage devices.
Rep Id : TMRGL75125 | Published | Electronics and Semiconductors | June 2022
Introduction of novel technologies; and innovation in automation, precision, and electronics industry verticals are boosting the development of system-on-chip products, thus creating lucrative opportunities for manufacturers of SoCs. Manufacturers are increasing their R&D activities to innovate in deep learning chips, machine learning chips, and artificial intelligence chips to broaden their
Rep Id : TMRGL5189 | Published | Electronics and Semiconductors | June 2022
The terahertz (THz) wave is an electromagnetic wave that has a spectrum range between microwave and the infrared. Terahertz waves have a frequency range of about 100 GHz to 10 THz, and wavelengths 3 mm to 30 µm.
Rep Id : TMRGL9119 | Published | Electronics and Semiconductors | June 2022
Point-of-purchase (POP) displays are a marketing and advertising strategy used in retail stores to promote specific merchandise to shoppers who are ready to make a purchase. POP displays are mainly located near the checkout counter or in certain other places of the store, such as floor and pallet, to drive
Rep Id : TMRGL84818 | Published | Electronics and Semiconductors | June 2022
Flexible substrates are playing an important role in the advancement of display devices, majorly in recent times, as the structural support and signal transmission path or medium. Flexibility is the ability of a material to bend without mechanical failure such as facture and plastic deformation. Currently, ultrathin glass, metal foil,
Rep Id : TMRGL15896 | Published | Electronics and Semiconductors | June 2022
Seismic survey is a method of exploring subterranean structure related to exploration for petroleum, natural gas, and mineral deposits. The procedure is based on determining the time interval that elapses between the initiation of a seismic wave at a selected shot point (the location where an explosion generates seismic waves)
Rep Id : TMRGL3943 | Published | Electronics and Semiconductors | June 2022
A real-time clock IC (RTC IC) is an integrated circuit that keeps track of the current time and date, typically counting seconds, minutes, hours, days, months, and years with leap-year compensation. These ICs are available in 12 hour and 24-hour time format with AM/PM display. Real-time Clock (RTC) ICs are
Rep Id : TMRGL59367 | Published | Electronics and Semiconductors | May 2022
CMP slurries are made of abrasive powder that is nano-sized and dispersed in a chemically reactive solution. While chemical etching softens the material, mechanical abrasion removes it, flattening the topographic features and creating a planar surface.
Rep Id : TMRGL36632 | Published | Electronics and Semiconductors | May 2022
The satellite industry is beginning to gain substantial advantage in the telecommunications market, with numerous businesses focusing on establishing low-earth orbit satellite constellations to provide affordable, high-speed Internet connectivity.
Rep Id : TMRGL81316 | Published | Electronics and Semiconductors | May 2022
Wide bandgap semiconductor technologies, such as Gallium Nitride Field Effect Transistors (GaN FETs), have been gaining traction for power management and conversion in different applications, from high power motor drives to fast charging adaptors, telecommunication, computing, to space applications.
Rep Id : TMRGL4657 | Published | Electronics and Semiconductors | May 2022
Most comprehensive coverage 100+ countries, 2 million+ data points
Personalized pre-sales, on-boarding, and post-sales support
Less assumption, more science a research methodology perfected through years of rigorous diligence
True to its name, transparency in every minute details from research processes to financials
20% of Fortune 500 are our clients have worked with over 3000 SMEs